Mazda is recalling a batch of 2.5L Mazda6 models because of a potential programming error that could see the fuel pump fail after i-Stop operation.

MAZDA AUSTRALIA IS recalling a batch of Mazda6 (GJ1031) Sedan and Wagons powered by the 2.5-litre four-cylinder due to a programming error with the Powertrain Control Module (PCM) which “may fail to provide an adequate supply of electric power to the fuel pump following i-Stop operation”.

According to Mazda, “This may cause the fuel pump to stop operating, preventing the engine restarting or stalling after initial take off [or after i-Stop operation]. If this occurs, the Malfunction Indicator Light (MIL) on the instrument panel will illuminate.

The vehicles being recalled were sold between 21 November 2013 – 2 October 2014 (JM0GJ103100125898 – JM0GJ103100132959).

Mazda Australia will contact all affected consumers by mail, advising them of the next steps. Consumers who require further information should contact Mazda Customer Support on 1800 034 411.

Previous

2014 Toyota Hilux Black, or, er, White revealed

Next

TopGear presenters attacked in Argentina

Leave a Reply

Your email address will not be published. Required fields are marked *

Check Also